An infrared (IR) lower explosive limits (LEL) sensor, as opposed to a catalytic bead, works based upon the absorption of infrared radiation at specific wavelengths as it passes through a volume of gas. While both an IR and catalytic bead LEL sensor are viable solutions for combustible gases, there are key differences that can make or break either sensor as a solution to fit your specific application with the Radius BZ1.
Due to the nature of an IR LEL sensor, oxygen is not required for the sensor to detect combustible gases, making the IR LEL sensor ideal for sampling in inert environments, like lines that are being purged. Since there is no oxygen required, sampling can also be done without additional equipment like dilution tubes. Instead, simply attach the required length of tubing to your pumped Radius BZ1 and you can begin sampling.
IR LEL sensors are not damaged by high gas concentrations, so users can also continue to sample in high LEL environments for prolonged periods of time without damaging the IR LEL sensor. IR LEL sensors also are not susceptible to poisons and inhibitors that can damage catalytic bead LEL sensors. Many poisons and inhibitors are bi-products and gases commonly found in environments where gas detection is needed, so you can significantly increase your sensor longevity by choosing an IR LEL sensor.
IR LEL sensors also use less power than a standard catalytic bead sensor, allowing for longer monitor runtime. For example, a non-pumped Radius BZ1 using a catalytic bead LEL sensor can run for 7 days, while the same configuration with a methane IR LEL sensor in place of the catalytic bead can run for 9.5 days.
Although IR LEL sensors have several benefits over standard catalytic bead LEL sensors, they do have some drawbacks that may make them unsuitable for your application. The main drawback is that IR LEL sensors are blind to some gases, the most common being hydrogen (H2) and acetylene (C2H2). IR LEL sensors will not detect these gases, so if you have the potential for either to be present in your application, you should not use an IR LEL sensor.
IR sensors can also display false readings due to humidity, especially when moving from cold to warm atmospheres. While these false readings can be a nuisance, they are self-correcting. If readings appear when your Radius BZ1 is moved from a cold to warm and humid atmosphere, simply wait for the sensor to stabilize on its own.
There are two IR LEL sensors available for the Radius BZ1, the Methane IR LEL and Hydrocarbon IR LEL. Both sensors measure from 0-100% LEL with a resolution of 1% LEL.
The Methane IR LEL sensor is designed to detect methane but has a very non-linear response for combustibles other than methane. Therefore, this sensor is best suited for use when you know the combustible gas being detected will be methane or natural gas.
The Hydrocarbon IR LEL sensor is designed to have a much more linear response to multiple combustible gases when calibrated to propane. Therefore, this sensor is best suited for use when you will be detecting a wide range of combustible gases. Using this sensor and knowing the gas being detected allows you to apply a correlation factor to calculate the actual concentration of the detected gas from propane. The Hydrocarbon IR LEL sensor has a limited response to methane.
For additional information on the Radius BZ1 with IR LEL sensors, talk to one of our gas detection experts or visit www.indsci.com/en/gas-detectors/area/radius-bz1.